<code id="obzzi"><ol id="obzzi"></ol></code>
      <meter id="obzzi"></meter>
    1. <meter id="obzzi"><u id="obzzi"></u></meter>
    2. LPC1311

      芯片信息

      型號 封裝 在線定購
      LPC1311FHN33(查看) HVQFN33

      引腳布局

      (點擊圖片看大圖)
      技術資料—— LPC1311 PDF技術資料
      LPC1311 參數
      LPC1311 存儲器
      Flash (KB) 8
      RAM (kB) 4
      LPC1311 其他參數
      fmax (MHz) 72
      I/Opins 28
      UART 1
      I2C 1
      I2S -
      SPI 1
      SSP 1
      ADC 8
      DAC -
      定時器 5
      PWM 11
      I/O 電壓 (V) 3.3
      CPU 電壓 (V) 3.3
      LPC1311 封裝與引腳
      HVQFN33

      LPC1311 概述

      The LPC1311 are ARM Cortex-M3 based microcontrollers for embedded applications featuring a high level of integration and low power consumption. The ARM Cortex-M3 is a next generation core that offers system enhancements such as enhanced debug features and a higher level of support block integration.

      The LPC1311 operate at CPU frequencies of up to 72 MHz. The ARM Cortex-M3 CPU incorporates a 3-stage pipeline and uses a Harvard architecture with separate local instruction and data buses as well as a third bus for peripherals. The ARM Cortex-M3 CPU also includes an internal prefetch unit that supports speculative branching.

      LPC1311 特性

      • ARM Cortex-M3 processor, running at frequencies of up to 72 MHz.
      • ARM Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC).
      • 8 kB on-chip flash programming memory.
      • 4 kB SRAM.
      • In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software.
      • Serial Wire Debug and Serial Wire Trace port
      • High-current output driver (20 mA) on one pin
      • High-current sink drivers (20 mA) on two I2C-bus pins in Fast-mode Plus
      • Three reduced power modes: Sleep, Deep-sleep, and Deep power-down
      • Single power supply (2.0 V to 3.6 V).
      • 10-bit ADC with input multiplexing among 8 pins
      • Integrated oscillator with an operating range of 1 MHz to 25 MHz.
      • Programmable watchdog oscillator with a frequency range of 7.8 kHz to 1.8 MHz.
      • Serial interfaces:
        • UART with fractional baud rate generation, modem, internal FIFO, and RS-485/EIA-485 support.
        • SSP controller with FIFO and multi-protocol capabilities
        • I2C-bus interface supporting full I2C-bus specification and Fast-mode Plus with a data rate of 1 Mbit/s with multiple address recognition and monitor mode
      • Other peripherals:
        • Up to 28 General Purpose I/O (GPIO) pins with configurable pull-up/pull-down resistors.
        • Four general purpose counter/timers with a total of four capture inputs and 13 match outputs.
        • Programmable WatchDog Timer (WDT).
        • System tick timer.



      久久爱免费视频在线观